nOTE:
The cleaner the filter is, the better the product will perform.
• The dust bowl can also be washed in warm soapy water as shown in figure H.
Ensure that it is dry before re-attaching.
•
Never immerse the product in water. A damp cloth and soapy water should be used
to clean the exterior of the motor section. Always ensure the product is completely dry
before re-use or storing.
RUn TIME
• When fully charged, the average effective usage times are between 10-15 minutes.
• It may take several chargings before these times can be achieved.
OTHER InfORMaTIOn
If the product does not work, check the following:
• The charger was correctly plugged in for recharge. (It feels slightly warm to the touch.)
• The charger cord is not damaged and is correctly attached to the base.
• The charger is plugged into a working electrical outlet.
aCCESSORIES
The performance of your appliance depends on the accessory used. Black & Decker
accessories are engineered to high quality standards and are designed to enhance the
performance of your appliance.
• Filter accessory number VF200SP.
MaInTEnanCE
Use only mild soap and damp cloth to clean the vac. Never let any liquid get inside the
vac; never immerse any part of the vac into a liquid.
nOTE:
Make sure the vacuum is completely dry before using it.
IMPORTanT:
To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service organizations, always using identical replacement parts.
THE RBRC™ SEaL
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack) indicates that the costs
to recycle the battery (or battery pack) at the end of its useful life have
already been paid by Black & Decker. In some areas, it is illegal to place spent
nickel-cadmium batteries in the trash or municipal solid waste stream and the
RBRC program provides an environmentally conscious alternative. RBRC in
7
TROUBLESHOOTInG
Problem
Possible Cause
Possible Solution
• Unit will not start.
• Battery not installed properly.
• Check battery installation.
• Battery not charged.
• Check battery charging
requirements.
• Battery will not charge. • Battery not inserted into charger.
• Insert battery into charger
until green LED appears.
• Charger not plugged in.
• Plug charger into a working
outlet.
Refer
to
“Important
Charging
Notes”
for
more
details.
• Check current at receptacle
by plugging in a lamp or other
appliance.
• Check to see if receptacle is
connected
to
a
light
switch
which
turns
power
off
when
you
turn
out
the
lights.
• Surrounding air temperature
• Move charger and tool to a
too hot or too cold.
surrounding air temperature
of above 40 degree F(4,5°C)
or below 105 degree F
(+40,5°C).
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
Summary of Contents for BDH1800S
Page 27: ...27 ...
