SmartSelect
TM
Dial - Fig. J
The steam mop is equipped with a
SmartSelect
TM
dial (20) which shows various
hard floor surface cleaning applications.
A Light will glow next to the selected
application. To change the application, press
and release the SmartSelect
TM
button (2)
repeatedly until the light glows next to the
correct operating mode for your particular
hard floor surface.
NOTICE:
Do not use on any unsealed
hard floor surfaces. Additionally, on surfaces
that have been treated with wax or some no
wax floors, the sheen may be removed by the heat and steam action. It is always
recommended to test an isolated area of the surface to be cleaned before proceeding.
We also recommend that you check the use and care instructions from the floor
manufacturer.
Using the SmartSelect
TM
button (2), choose from one of the following applications:
The steam mop will select the correct volume of steam required for your particular
cleaning operation.
NOTICE:
SmartSelect
TM
has a memory. Switching the steam mop on will recall the
previously used setting.
STEAM BURST BUTTON - Fig. J
The steam burst button is a built in feature that aids in the removal of stubborn floor marks or
stuck on grime.
• To apply an extra burst of steam to trouble areas, press the Steam Burst button (19).
NOTICE:
The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
NOTICE:
This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds
HINTS FOR OPTIMUM USE
GENERAL USE
CAUTION:
Never use the steam mop without first attaching a cleaning pad.
WARNING:
It is important to monitor the water level in the water tank. To refill the
water tank and continue to sanitize/clean, see Filling the Water Tank section.
NOTICE:
Never leave the steam mop in one spot on any surface for any period of time.
Do not store with a wet pad as this can damage your floor. Always place the steam mop
with the handle (4) in the upright position when stationary and make sure the steam mop is
turned off when not in use.
• Always vacuum or sweep the floor before using the steam mop.
• The easiest way to use the steam mop is to tilt the handle to a 45˚ angle and clean
slowly, covering a small area at a time.
• Do not use chemical cleaners with your steam mop.
To remove stubborn stains
7
20
J
