QUICk ReLeASe CHUCk (fIg. H)
NOTe:
The chuck accepts 1/4 inch (6.35 mm) hex
accessories only.
WARNINg:
Remove battery pack before
changing accessories.
To install an accessory
, pull the chuck collar (3)
away from the front of the tool, insert the accessory,
and release the collar. The accessory is locked in
place.
To remove an accessory
, pull the chuck collar
(3) away from the front of the tool, remove the
accessory and release the collar.
ON bOARD bIT STORAge
A bit storage slot is built-in to the area on the top of
the drill.
TROUbLeSHOOTINg
Problem
Possible Cause
Possible Solution
• Unit will not start.
• Battery pack not installed
• Check battery pack
properly.
installation.
• Battery pack not charged.
• Check battery pack charging
requirements.
• Battery pack will not
• Battery pack not inserted into • Insert battery pack into
charge.
charger.
charger until green LED appears.
• Charger not plugged in.
• Plug charger into a working
outlet. Refer to “Important Charging
Notes” for more details.
• Surrounding air temperature • Move charger and battery
too hot or too cold.
pack to a surrounding air temperature of
above 40 degrees F (4.5°C) or below
105 degrees F (+40.5°C).
• Unit shuts off abruptly. • Battery pack has reached its • Allow battery pack to cool
maximum thermal limit.
down.
• Out of charge. ( To
• Place on charger and
maximize the life of the
allow to charge.
battery pack it is designed
to shutoff abruptly when
the charge is depleted.
)
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTeNANCe
9
g
5
h
3