4
ENGLISH
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning!
Never attempt to replace the charger unit with
a regular mains plug.
X
Use your Black & Decker charger only to charge the
battery in the appliance/tool with which it was supplied.
Other batteries could burst, causing personal injury and
damage.
X
Never attempt to charge non-rechargeable batteries.
X
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
X
Do not expose the charger to water.
X
Do not open the charger.
X
Do not probe the charger.
X
Do not cover the charger.
The appliance/battery must be placed in a well ventilated
area when charging.
The following symbols are found on your charger:
Electrical safety
X
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features:
1. Flexible hook
2. LED light bar
3. Battery status LED
4. On/off/brightness switch
5. Charging socket
6. Mains charging adaptor
7. Charger jack plug
Use
Charging the light bar (fig. A)
X
Insert the charger jack plug (7) into the charging
socket (5).
X
Insert the mains charging adaptor (6) into a mains
power socket.
X
The red battery status LED (3) will light to show that
the battery is charging.
X
Do not charge for more than 40 hours.
X
Remove the mains charging adaptor (6) from the
charging socket (5).
X
After charging, wait for 5 minutes before using the
light bar.
Using the flexible hook (fig. B and C)
X
The flexible hook (1) may be used to store, support or
suspend the light bar.
X
The flexible hook allows the light bar to be set in any
position (fig. B).
X
Make sure that the flexible hook is secure around the
supporting object.
Operating the light bar
X
Press the on/off/brightness switch (4) once for the high
brightness setting.
X
Press the on/off/brightness switch (4) again for the low
brightness setting.
X
To turn the light bar off, press the on/off/brightness
switch (4) a third time.
Your charger is double insulated; therefore
no earth wire is required.
Fail-safe isolating transformer. The mains supply is
electrically separated from the transformer output.
The charger automatically shuts off if the
ambient temperature becomes too high.
As a consequence the charger will be inoperable.
The charger must be disconnected from the
mains supply and taken to an authorised service
centre for repair.
The charger is intended for indoor use only.
The charger is double insulated; therefore no earth
wire is required. Always check that the power supply
corresponds to the voltage on the rating plate.
130
o
C
