Black & Decker 11BDE-210, Instruction Manual

Page: 5 / 40

5 - ENG
9. This product is provided with a
Ground Fault Circuit Interrupter
built into the power cord plug. If
replacement of the plug or cord
is needed, use only identical
replacement parts.
10. Do not touch plug or outlet with
wet hands.
11. Avoid accidental starts. Move
switch on unit to OFF position
before connecting or disconnecting
cord to electrical outlets.
12. Water spray must never be
directed towards any electric
wiring or directly towards the
pressure washer machine itself or
fatal electric shock may occur.
13. Never carry your pressure washer
by the cord. Do not pull on the cord
to disconnect from the outlet.
14. To prevent damage, the cord
should not be crushed, placed next
to sharp objects or near a heat
source.
15. Check power cords before using.
Damaged cords can reduce
performance of pressure washer or
cause a fatal electrical shock.
16. The narrow pin point stream is very
powerful. It is not recommended
for use on painted surfaces, wood
surfaces or items attached with an
adhesive backing.
17. Keep operating area clear of all
persons and ani mals.
18. Always use both hands when
operating pressure washer to
maintain complete control of the
wand.
19. Do not touch nozzle or water spray
while operating. Never place hands
in front of nozzle.
20. Wear safety goggles while
operating. Wear protective clothing
and footwear to protect against
accidental spraying.
21. Disconnect power plug from the
outlet when not in use and prior to
the detaching of the high pressure
hose.
22. Never tie knots or kink the high
pressure hose as da mage could
result. Inspect the high-pressure
hose regularly. Replace the hose
immediately if it is damaged, worn
or shows any signs of cracks,
bubbles, pinholes, or other leakage.
Never grasp a high-pressure hose
that is leaking or damaged.
23. Do not operate or store this product
in temperatures below 40° F (4° C).
Freeze damage is not covered by
the warranty.
24. Carefully observe all chemical
instructions and warnings
before using. Use only approved
pressure washer cleaners. Do
not use bleach, chlorine, or any
cleaners containing acids. Always
follow manufacturer’s label
recommendations for proper use
of cleaners. Always protect eyes,
skin and respiratory system from
cleaners.
25. The pressure washer should not
be used in areas where gas vapors
may be present. An electric spark
could cause an explosion or fire.
26. To minimize the amount of water
getting into the pressure washer,
the unit should be placed as far
as possible from the cleaning site
during operation.
27. To prevent accidental discharge,
the spray gun should be secured
by locking the trigger when not in
use.
28. To allow free air circulation, the
pressure washer should NOT be
covered during operation.
29. Never touch, grasp or attempt to
cover a pinhole or similar water
leak on the high-pressure hose.
The stream of water IS under high
pressure and WILL penetrate skin.
30. Use only hoses and accessories
rated for pressure higher than
your pressure washer's psi. Never
use with any other manufacturer’s
accessories or components.