BKI DRG-40, Installation And Operation Manual, Page: 11 / 40

Gas Rotisserie Oven Operation
9
Item # Description Function
1 HEAT ON LED Illuminates to indicate that the top burners are on. It cuts off only when
the temperature is reached.
2 TIME/TEMP Display Shows time/temperature and other messages during operation.
3 Program LEDs (1-5) Illuminates to represent the program selected.
4 Function Buttons ITEM SELECT - This button is used to select the program. When this
button is pressed, the controller advances to the next program and its
associated LED illuminates.
START/STOP - This button is used to start and stop a cook or hold
cycle.
UP AND DOWN ARROWS - These buttons are used for setting
time/temperature by incrementing or decrementing to the desired value.
These buttons are used in conjunction with the
COOK TEMP ,
COOK TIME , HOLD TEMP , and HOLD TIME buttons.
COOK TEMP - This button is used to review and/or change the cook
temperature for the individual program.
COOK TIME - This button is used to review and/or change the cook
time for the individual program.
HOLD TEMP - This button is used to review and/or change the hold
temperature for the individual program.
HOLD TIME - This button is used to review and/or change the hold time
for the individual program.
REVIEW –
This button is used to review and/or change a setting for
any program.
5 POWER ON/OFF Switch Controls power to the entire unit.
6 HEAT ON/OFF Switch Controls ignition of top burners if ROTOR and POWER switch are on
and doors are shut.
7 LIGHTS ON/OFF Switch Controls power to the lights inside oven.
8 ROTOR ON/OFF Switch Controls power to the motor that turns the rotors if the POWER switch
is on.
9 LOWER FLAME ON/OFF
Switch
Controls ignition of lower burner if the doors are closed and the ROTOR
is on. This burner does not cycle on and off as does the top burner.
10 PUSH TO RESET Switch Pressing this switch resets power to the rotor motor when the motor
experiences an overload condition.
11 WATER FILL Switch Controls the flow of water into the bottom of the unit. Press and hold
this switch to cause water to flow. Fill the pan to approximately ¼” (6.3
mm.) of water to assist cleaning of unit.
12 ROTOR JOG Switch Controls power to the motor that turns the rotors when the doors are
open, the
ROTOR switch is on and the POWER switch is on. Press and
hold this switch to cause the rotors to turn.
13 Drain Lever Controls the drain valve inside the unit. To open the valve, place the
lever in the vertical position. To close the valve, place the lever in the
horizontal position.