BKI 1.06, Service Manual, Page: 14 / 60

Combi-Oven Installation
12
U3: Adjusting Temperature Sensors (Pt-100)
The digit of the sensor in use is shown in the program display (17).
1 = oven chamber, 2 = probe, 3 = steam generator, 4 = condensation
Change the digit by pressing the program key (17).
The current temperature is shown in the temperature display (5).
The set point is shown in the core temperature display (8)
Standard set point = 100, which can be adjusted downwards to 80 and upwards to 120 with the arrow
keys.
Each temperature sensor can be adjusted/corrected by approx. +/-10°C, i.e. the temperature changes in
steps of 0.5°C.
The core temperature display holds only 2 digits, consequently 80 = 80, 00 = 100 and 20 = 120.
U4: Selecting Pre-Set/Current Temperature, Combiclean, Additional
Detergent, Showdisplay And Printer
Pre-set/current temperature
1 or 0 is shown in the time display (1).
0 = Pre-set temperature (standard)
1 = Current temperature during operation
Shift by pressing (3).
CombiClean
The oven size is shown in the temperature display (5).
You change between oven sizes by pressing the temperature key (7).
Additional Detergent
If the oven chamber is not properly clean when the cleaning program is completed, it is possible to add
additional detergent.
Press the key for manual humidity (24) until the control lamp is turned on. ”Additional detergent” is now
active.
Note that the programs are prolonged by 5 m the detergent phase.
If the control lamp is off, this function is off.
Demo mode
It is possible to select a demo mode in which the oven rinses only.
Press the exhaust key (19)until the control lamp is turned on.
Showdisplay
Press (17) until the display shows 1.
The control lamps in (23) and (22) flash to indicate that the keys are active.
By pressing (23), you reserve memory in the showdisplay for the 16 programs.