BK Radio KNG Series, Service Manual, Page: 53 / 248

Page 2-38 Service Manual - KNG Portables
operation and Programming
tx frequency
Enter a valid receive frequency in MHz. Frequencies must be divisible by 1.25kHz.
tx mode
Select Analog, Digital or Selectable.
tx Guard
Analog or Mixed Mode Receive Channels Only
Select “Off” for analog signals to operate in carrier squelch mode.
Select “Tone” to enter a CTCSS tone,
Select “Digital” to enter a DCS value.
Use “INV” to invert a DCS tone.
tx naC
Analog or Mixed Mode Transmit Channels Only
Select “Enter” to program a transmit NAC via the keypad.
Enter the desired value in hexadecimal (000 - FFF).
NOTE: $F7E and $F7F are invalid transmit NACs.
Choose “Select” to use a transmit NAC from the pick list.
tGiD
Analog or Mixed Mode Channels Only
Select “Enter” to program a transmit Talk Group ID via the keypad.
Enter the desired value (1- 65535).
NOTE: 0 is an invalid transmit Talk Group ID.
Choose “Select” to use a TGID from the pick list.
P25 iD Unit Call/reCeiVe list
The KNG can be pre-programmed with up to 100 Project 25 IDs and labels. If ‘RX’d Unit ID’ is
designated as a display line, the P25 ID of the radio sending the call will be shown when receiving a
digital signal. If the P25 ID of the received call is programmed in the Call List, the alphanumeric label
associated with the ID will be displayed. If the P25 ID is not in the Call List, the numeric P25 ID will be
displayed.
Select “Call List” from the programing menu.
Select the P25 ID you wish to edit.
The display shows the label and P25 ID of the selected ID.
Select “Label” to edit or add an alphanumeric label
Select “Dest ID” to change the P25 ID
User seleCtaBle CoDe GUarDs
The KNG can be pre-programmed with up to 32, user selectable, CTCSS or CDCSS subaudible
tones. Tones are selected via a programmed button or menu item (see TX/RX CxCSS Picklist). If
enabled, the tones can be programmed via the radio’s keypad.
Select “User Tones” from the programing menu.
Select the tone to edit.