31
APPLICATIONS (CONT.)
MATV APPLICATIONS
Master antenna systems for hotels, motels, apartment
buildings, etc. can be checked by applying the channel 3 or 4
rf output of the Generator to the input of the network (or a
branch of the network) and examining the pattern obtained
on channel 3 or 4 directly from the screen of each TV set.
To isolate problems in the distribution network from
problems in an individual TV set, apply the channel 3 or 4 rf
output of the NTSC Generator directly to the antenna
terminals of the TV set. A proper display on the screen
indicates that there is a problem in the distribution network.
VECTORSCOPE MEASUREMENTS
A vectorscope measurement is usually more helpful for
trouble analysis than observing the pattern displayed on the
picture tube. If an NTSC Vectorscope is available, it is
recommended. The display on an NTSC Vectorscope with
the NTSC color bars pattern applied should be six dots located
within the six small boxes of the Vectorscope as shown in Fig.
3. The displayed vector pattern may be extracted from
anywhere in the composite video or 3.58MHz color circuits.
Amplitude must be initially adjusted so the color burst aligns
with the 75% mark on the vectorscope graticule.
If an NTSC vectorscope is not available, the demodulated
color signals from the red and blue guns can be used as the
X and Y inputs to a good laboratory oscilloscope (such as the
B+K Precision
Model 2120). The resulting display is a
vectorscope pattern as shown in Fig. 7. The oscilloscope
should be set up for vectorscope operation as follows:
1.
Select the
NTSC BARS
pattern and apply to the TV set
under test.
2.
Set up to the oscilloscope for X-Y operation. Adjust the
position controls to center the dot on the screen with no
signal
In
p
ut to the oscilloscope.
3.
Connect the X and Y inputs of the oscilloscope to the red gun
as shown in Fig. 5.
4.
Adjust the vertical and horizontal oscilloscope gain to equal
amounts. This will cause the spot to become a 45° line as
shown in Fig. 5.
5.
Leave the vertical (Y) input connected to the red gun but
move the horizontal input to the blue gun as shown in Fig. 6.
6.
A display similar to that shown in Fig. 7 should
be
obtained.
However, several factors may affect the display as follows:
a.
The HUE control of the TV under test will rotate the
display. The HUE control may be adjusted to obtain the
display nearest to that shown in Fig. 7. Starting from a
centered position, the HUE control can typically rotate
the display ±30
b.
The COLOR control of the TV under test (chroma
amplitude) adjusts the amplitude of the display. This
control should typically be adjusted for the highest
amplitude obtainable without distortion (just below the
point where further rotation of the control does not
increase amplitude of display).
Summary of Contents for 1249B
Page 1: ...INSTRUCTION MANUAL Model 1249B NTSC GENERATOR ...
Page 16: ...16 THE NTSC COLOR VIDEO SIGNAL CONT Fig 3 Elements of Color Television Signal ...
Page 20: ...20 CONTROLS AND INDICATORS CONT Fig 4 Controls and Indicators ...
Page 35: ...35 MAINTENANCE CONT R7 Fig 8 Adjustment and Test Point Locations ...
