EN
10
5-4. DC Current Measurements
CAUTION :
Do not make 10A current measurements for longer than 30
seconds. Exceeding 30 seconds may cause damage to the meter and/or the
test leads.
1.
Insert the black test lead banana plug into the negative
COM
jack.
2.
For current measurements up to 6000µA DC, set the function switch to the
µA/HZ/%
position and insert the red test lead banana plug into the µA/
mA jack.
3.
For current measurements up to 600mA DC, set the function switch to the
mA/HZ/%
position and insert the red test lead banana plug into the µA/
mA jack.
4.
For current measurements up to 10A DC, set the function switch to the
10A/HZ/%
position and insert the red test lead
banana plug into the
10A
jack.
5.
Press the
MODE
button to indicate “
DC
” on the
display.
6.
Remove power from the circuit under test, then
open up the circuit at the point where you wish to
measure current.
7.
Touch the black test probe tip to the negative side
of the circuit.
8.
Touch the red test probe tip to the positive side
of the circuit.
9.
Apply power to the circuit.
10. Read the current in the display.
Exe_Notice_BIZ780312_EN-FR-NL.indd 10
15/05/2019 17:37
