BIXOLON SMP6200II, User Manual, Page: 55 / 70

Rev. 1.00
- 55 -
SMP6200II
12. Designing the device to release the jamming of moving
blade
When the power is off while the moving blade is in a forward position or when moving
blade is used manually, the moving blade may be jammed with the fixed blade causing
problems in releasing the platen roller block.
- In order to release the condition when the system stops while the moving blade is in a
forward position, turn off the terminal, and turn it on again to release the condition.
Conduct sufficient verification by actually using the device.
- If the power cycling does not clear the condition, then select and design one of the four
methods to clear the cutter jam condition.
12-1 Designing the structure to clear the condition using tools
12-1-1 Designing the structure to clear the condition using tools
When designing the structure to release the cutter jam using thin and long tools such as a
screwdriver or pen to push the button, refer to the following.
※
The structure of the SMP6200 printer mechanism is designed to avoid cutter jam, and
designing the device to remove the cutter jam using the tool is recommended.
Fig 12-1 Example illustration of designing the method to clean cutter jam using tools
Fig 12-2 Recommended size of holes in outer case
Hole A
Recommended dimension of holes in outer case
- Ball-pen & Hand driver: Ø 9
- Hand driver: Ø5