Dismounting Modules
Before dismounting modules, make sure the device is physically disconnected from AC power! Never
operate the BIT-2100 with any module slot uncovered!
Always use proper ESD (electrostatic discharge) protective equipment when preparing, mounting or
dismounting modules. ESD can destroy the electronic components of the BIT-2100 Series Switch
System.
To dismount a switch module or a filler panel, follow these instructions:
1. Make sure the device is powered off and all cables are disconnected
2. Dismount the two screws at the very top of the module and the two screws at the very
bottom of the module (below the handle) using a Torx T8 screwdriver (see Figure 13)
3. Carefully pull the module out (see Figure 14)
◦
Note that switch modules are in a red plastic rail, so you can only pull them out straight
4. Close the opened slot, either by a filler panel, or by another module
BIT-2100B User Manual
39
Figure 13: Removing screws from modules
Figure 14: Removing a module