BitaTek IT-6000 Series, User Manual, Page: 37 / 72

37
Installing the Main Battery Pack
The main battery must be installed in the device before you can
charge it in the docking cradle.
Complete the following instructions to install the battery.
1.
On a device, detach the elastic handstrap by releasing its hook
from the handstrap connector at the base of the unit.
2. Pull the cover latch to unlock the battery door. Remove the
door.
3. Make sure to turn on the Backup Battery Switch.
4. Insert the battery with the pull tab on the outside and the
battery contacts aligned with the matching contacts inside the
battery compartment.
5. The main battery pack has a keying feature on one side to
prevent incorrect installation.
6. Replace the battery door by inserting the bottom tab into the
slot. If the battery is installed incorrectly, the door will not seat
properly.
7. Pull the latch on the battery compartment cover towards the
base of the unit.
8. On the device, replace the handstrap hook on the connector at
the base of the unit.
Figure 2.
Installing main battery