Magicians SOCD Cleaner V2
Section 6: Electrical
INSTALLATION MANUAL & USER GUIDE
REV B
PAGE 10
Button Input Screw Terminal Block
Wire your buttons to this terminal block. Note that there is no standard color code. The
harness for your buttons is usually colorful but the color code highly depends on the button
harnesses you have. For easier wiring, it is advisable to purchase an All-Button Harness.
Pin #
Name
Typical Color
1
GND
BLACK
2
RIGHT
BLACK
3
LEFT
BLACK
4
UP
BLACK
5
DOWN
BLACK
Connection Type:
Screw Terminal, 18-30AWG wire
Connector Map Number:
3
Cleaned Output Port
This is where the output comes from. The inputs from the direction buttons are used to create
a cleaned (or rather a magical!) output.
Pin #
Name
Typical Color
1
GND
BLACK
2
MAPPABLE
GREEN
3
MAPPABLE
YELLOW
4
MAPPABLE
ORANGE
5
MAPPABLE
RED
Connection Type:
JST NH, male header
Connector Map Number:
4
If using a board with positive logic (like a zero delay board), it
will likely have pin 1 as 5V so do not connect it to the Cleaned
Output Port! If you do, you run the risk of damaging your setup
or anything it is connected to. Be extremely careful!
Pin 1
Pin 1
