www.BISSELL.com
10
Cleaning with Hose and Tool
2
1
Insert the hose and snap into
place. Be sure the coloured
hose release clip is facing out,
away from machine.
Important:
Prime the hose by
holding at ground level and
pressing the spray trigger until
solution starts to dispense out
of the spray tip. Then, release
the spray trigger and proceed
to step 3.
Press the spray trigger button to spray the soiled area,
then slowly move tool back and forth over the area.
Release the spray trigger to suck up the dirty solution.
Work in small sections until the area is clean.
When finished cleaning, suction up warm clean water
from a tap or bowl to rinse the inside of the hose and tool.
Detach the hose and tool and close the accessory hose
door. Let the hose and tool air dry before storing.
Turn the machine off and
unplug from the earthed
outlet. Lift accessory hose
door on top of foot on
the front of the machine.
The door flips toward the
machine to open.
3
4
NOTE:
If using a
Deep Reach Tool
(select models only), be sure the needles of the
tool are pressed down into the carpet so the spray gets into the carpet fibres.
• Keep hair, loose clothing, fingers, and all parts
of body away from openings and moving parts.
Brushroll continues to rotate when in the upright
position.
• Brushroll continues to turn while product is turned
on and handle is in upright position. To avoid
damage to carpet, rugs, furniture and flooring, avoid
tipping cleaner or setting it on furniture, fringed area
rugs, or carpeted stairs during tool use.
• With brushroll on, do not allow cleaner to sit in one
location for an extended period of time, as damage
to floor can result.
Attach the tool
to the end of
the hose (tools
may vary by
model). Plug
into a properly
earthed outlet
and press
the power
button to turn
machine on.
EN
