P
repared by Monique Lania
9
Call Servicing Guide QuickWash
1950F.doc
How to change
(remove and fit) brush/bare floor attachment
Solution 1:
Press detent lever so that machine is laying flat on the ground
Release grey rectangle shaped latches on each side (left & right) of the blue
dirty water collection tank by pulling them in an up and then down motion
Remove the blue dirty water collection
There are two grey pieces of plastic where the brush sits sticking up through 2 holes. Push these
pieces of plastic towards each other with your thumbs and down so that the brush drops down, out
from the base of the bottom of the unit
Now simply place the other attachment on the machine by aligning the grey
plastic tabs into the holes and pushing up to click the attachment in place
**NOTE: The brush (broom like attachment is for use on carpets)
The attachment with the foam and squeegee is for use on bare floors
(The squeegee must face towards the front)
