www.BISSELL.ca
12
Cleaning with Hose & Tool
Insert the hose and
snap into place.
Be sure the colored
hose release clip
is facing out, away
from machine.
Press the spray trigger button to spray
the soiled area, then slowly move tool back
and forth over the area.
Release the trigger to suck up the dirty
solution. Work in small sections until the
area is clean.
When finished cleaning, turn the machine
on to suction up warm clean water to rinse
the inside of the hose and tool. Detach the
hose and tool and close the accessory hose
door. Let the hose and tool air dry before
storing.
Attach the tool to the end of the hose.
(Tools may vary by model.) Press the
power button to turn machine on.
NOTE:
If using the
Deep Reach Tool
or
Pet Stain Tool
be sure the needles of the
tool are pressed down into the carpet so the spray gets into the carpet fibers.
—
Keep hair, loose clothing, fingers, and all parts
of body away from openings and moving parts.
Brushroll continues to rotate when in the upright
position.
—
Brushroll continues to turn while product is
turned on and handle is in upright position. To avoid
damage to carpet, rugs, furniture and flooring, avoid
tipping cleaner or setting it on furniture, fringed
area rugs, or carpeted stairs during tool use.
—
The brushroll remains on while cleaning with the
hose and tool. Do not allow cleaner to sit in one
location for an extended period of time, as damage
to floor can result.
Lift the accessory
hose door on top
of foot on the front
of the machine. The
door flips toward the
machine to open.
Cleaning with CleanShot
Press the CleanShot button
with your foot. The window
of the button will be green
and show an “I” symbol
when it is on.
Spray will continue until you
turn it off. To turn CleanShot
off
, press the button with
your foot. The window of the
button will be red and show an
“O” symbol when it is off.
Completely
cover the stain
with CleanShot
spray. Allow the
stain to soak. To
extract, maneuver
the foot of the
machine over the
stain to brush and
remove.
1
2
3
4
1
2
