www.BISSELL.ca
16
Replacing Belts & Brush Rolls
Brush Roll & Nozzle Care (Continued)
What you will need: 1 Phillips screwdriver & 1 flathead screwdriver
Use a flathead
screwdriver and
press it into the
slot at the back
and then front
of
the belt access
door. Lift to
remove the Belt
Access Door.
While the machine is upright, unplug the machine and remove both tanks. Remove
the nozzle and brush chamber cover (see steps in Brush Roll & Nozzle Care). Press
the recline pedal and lay the machine on its back.
When finished, return the brush roll cover by
pushing it straight down. You will hear a click
from each “push” button when the cover is
pushed down into place. Line up the nozzle from
the edge near the floor and rotate to snap back
into place.
Turn the machine on its side and use
a Philips screwdriver to remove the
screw just underneath the wheel.
Slide the wheel down to remove.
Use the comb to brush out the
debris or hair from the brush rolls.
Lay the machine
back down on
its back. Use a
Phillips-head
screwdriver to
remove the screw
on the brushroll
end cap.
click
If the Gear Belt
is broken, gently
remove it. If you
are replacing your
brush rolls, gently
remove the belt.
5
6
1
2
3
4
5
