www.BISSELL.ca
17
Replacing Belts & Brush Rolls
What you will need: 1 Phillips-head screwdriver & 1 flathead screwdriver
Use a flathead
screwdriver and
press it into the slot
at the back
and
then front
of the
Belt Access Door.
Lift to remove the
door.
While the machine is upright, unplug the machine and remove both tanks. Remove
the nozzle and Brush Roll cover (see steps in Brush Roll & Nozzle Care). Press the
Recline Pedal and lay the machine on its back.
Turn the machine on its side and use
a Phillips-head screwdriver to remove
the screw just underneath the wheel.
Slide the wheel down to remove.
Lay the machine
back down on
its back. Use a
Phillips-head
screwdriver to
remove the screw
on the Brush Roll
end cap.
If the gear belt
is broken, gently
remove it. If you
are replacing your
Brush Rolls, gently
remove the belt.
There are washers
at the ends of the
Brush Rolls, be
careful that these
do not fall off or
get lost.
NOTE:
To replace Brush Rolls, remove them from the metal posts and replace.
Make sure the metal post goes completely through the end of the Brush Roll.
The bristles should be aligned in a ‘V’ pattern as pictured.
1
2
3
4
5
6
Align Brush Rolls with belt
at other end. To ensure
alignment, hold the end
of one Brush Roll and
twist. The other Brush
Roll rotates with it.
Check
that washers are in place.
Reassemble the belt and
end cap, securing with
screws you removed.
WARNING
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting checks.
Summary of Contents for PROHEAT 2X REVOLUTION 1986 Series
Page 21: ...www BISSELL ca 19 Notes...
Page 43: ...www BISSELL ca 19 Remarques...
