Operations
Carpet cleaning
1.
Set ReadyTools dial to “FLOOR CLEANING”.
2.
Plug into proper outlet.
3.
Turn the power switch to the ON (I) position
(located on the back of unit)
4.
With foot, press the red recline lever
(located on the back of unit).
NOTE: Handle must be fully reclined for the
brush to turn.
5.
Cleaning Strokes. While pressing the spray
trigger, make one slow forward wet pass and
another one back.
Caution: Do not overwet.
6.
Release the spray trigger and make one
slow forward and backward pass over
the same area.
7.
Repeat steps 5 and 6 until solution being
pulled up appears clean.
8.
Empty the collection tank when dirty water
reaches the full line, or when the solution tank
is empty.
Empty the collection tank
1.
Turn power switch OFF (O) and unplug power
cord from outlet.
2.
Remove the collection tank from base of unit.
a.
Release collection tank latches
(on each side) by pulling up from the
bottom of latch and then out.
b.
Carefully remove the top of the
tank by lifting up on the tank handle.
3.
Carry collection tank to a toilet or sink. To
empty, pour out contents using opening at back
of tank.
4.
Rinse collection tank thoroughly and replace
on unit.
5.
Refill solution tank and continue cleaning.
www.BISSELL.com
8
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
2a.
3.
2b.
Carry Handle
Empty Opening
CAUTION
Take care not to run over loose objects or edges of
area rugs. Stalling the brush may result in premature
belt failure.
3. & 4.
1.
Recline
Lever
Power Switch
