16
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
10
Cleaning the pre-motor filter
The pre-motor filter protects the motor from
dirt and dust particles.
1.
Turn vacuum OFF
( )
. Unplug the vacuum
from electrical outlet.
2.
Open the dirt cup compartment by lifting up
the door latch on the front of the vacuum.
Lift out the dirt cup.
3.
Remove the filter frame from the filter
holder by grasping the lip of the frame and
pulling up.
4.
Remove the filter from the filter frame and
clean by hand washing in warm water. A mild
detergent can be used if desired. Allow the
filter to air dry thoroughly before replacing.
5.
Place the filter back into the filter frame and
replace back into the filter holder.
noTE: The filter frame should be placed so
the protective frame is visible.
6.
Place the dirt cup back into the dirt cup
compartment.
7.
Close dirt cup compartment door and press
down gently until it locks into place.
M
aintenance and care
Washable Pre-
Motor Filter
noTIcE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete or
ashes will damage the motor and void
the warranty.
Tip:
For maximum cleaning performance,
check the filters often and clean or
replace if necessary.
WaRnInG:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
3.
WaRnInG:
To reduce the risk of
electric shock, turn
power switch off and
disconnect plug from
electrical outlet before
performing maintenance
or troubleshooting
checks.
