BISSELL.com
5
Note:
Before cleaning rugs, check the manufacturer’s tag and test an inconspicuous spot for
colorfastness. Don’t use on silk or delicate rugs.
Power
Trigger
Mode
1.
Press power button ON.
Press mode button to switch
between modes. Area Rug
Mode & Turbo Mode dispense
double the solution of Hard
Floor Mode. Turbo Mode
increases suction performance.
2.
Recline to start the brush
roll spinning. Brush roll will not
spin when machine is upright.
Note:
Laying machine flat or
sideways will cause the dirty
water tank to leak.
3.
Hold trigger for 10
seconds to wet brush roll.
LEDs illuminate when holding
the trigger. Bubbles appear
in window when solution is
flowing.
1.5s
Power
4.
Hold the solution spray
trigger to apply solution on
forward and backward passes.
5.
Release the trigger and
make forward and backward
passes without dispensing
solution. To dry floors faster,
make additional dry passes.
6.
Press power button OFF.
The battery icon will beep
for 1.5 seconds while shut
off is in progress. Do not
move machine until it finishes
powering down.
Cleaning with Hard Floor Sanitise Formula
Please read “DIRECTIONS FOR USE” on Hard Floor Sanitise label. Use on hard nonporous floors only.
1.
Remove visible soil before
cleaning. Hold trigger down to
apply solution to the floor.
2.
Allow formula to remain wet
on the floor for five minutes.
This may require additional
wet passes.
3.
With the trigger released,
make forward and backward
passes to extract solution.
ATTENTION
• Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area rugs. Stalling the brush may
result in premature belt failure.
• This machine is designed to be used on sealed hard floors and area rugs.
Cleaning Your Floors
