BISSELL.com
5
Digital Display
Cleaning Your Floors
Note:
Before cleaning rugs, check the manufacturer’s tag and test an inconspicuous spot for
colorfastness. Don’t use on silk or delicate rugs.
Power
Trigger
Mode
1.
Press power button ON.
Press mode button to switch
between Hard Floor and Area
Rug Modes. Area Rug Mode
dispenses double the solution
as Hard Floor Mode.
2.
Recline to start the brush
roll spinning. Brush roll will not
spin when machine is upright.
Note:
Laying machine flat or
sideways will cause the dirty
water tank to leak.
3.
Hold trigger for 10
seconds to wet brush roll.
LEDs illuminate when holding
the trigger. Bubbles appear
in window when solution is
flowing.
Power
4.
Hold the solution spray
trigger to apply solution on
forward and backward passes.
5.
Release the trigger and
make forward and backward
passes without dispensing
solution. To dry floors faster,
make additional dry passes.
6.
Press power button OFF.
The battery icon will beep
for three seconds while shut
off is in progress. Do not
move machine until it finishes
powering down.
1. Hard Floor Mode
2. Area Rug Mode
3. Dirty Water Tank Full
4. Battery Status
5. WiFi Connected
5
4
3
1
2
ATTENTION
• Do not overwet carpet or hardwood floors. Be careful not to run over loose objects or edges of area rugs. Stalling the brush may
result in premature belt failure.
• This machine is designed to be used on sealed hard floors and area rugs.
CONTINUED ON NEXT PAGE
