w w w . b i s s e l l . c o m
M
aintenance and care
12
The post-motor HEPA media filter*
assists in the filtration process to
return clean air to the room. Use only
BISSELL replacement filters in your
PowerForce Multi Cyclonic.
1.
Turn the power OFF. Unplug the vacuum
from the electrical outlet.
2.
The post-motor filter is located behind
the door labeled “FILTER” on the rear of
the vacuum. Open the door by pushing
down on the tab of the door and pulling
out to remove.
3.
Remove the post-motor HEPA media filter*
by grasping the handle on the filter and
pulling out to remove.
4.
Replace the post-motor HEPA media filter*
with a new filter.
NOTE: The post-motor filter is a
white, pleated HEPA media filter*.
This filter is NOT washable and
must be replaced when it becomes
dirty.
5.
Replace the filter door by inserting the two
tabs at the bottom of the filter door. Then
push down on the tab on the door and
push it back into the vacuum. Release the
tab on the door to lock into place.
Cleaning the Post-motor HEPA media filter*
Post-Motor HEPA
MediaFilter*
2.
3.
*The filter, media, not the vacuum as a whole, complies
with the IEST-RP-CC001.5 HEPA Standard
