www.BISSELL.com.au
9
Operations
4.
3.
9.
8.
Cleaning with Attachments
Your cleaner is equipped with a hose and
one attachment for cleaning stairs, upholstery
and more. When the power is ON and the
machine is in the upright position, your carpet is
protected because the brush is elevated above
the carpet (take care if long fibre carpet or mats
are in proximity).
1.
Important! If using to clean upholstery, check
upholstery tags.
1a.
Check manufacturer’s tag before cleaning.
Do not use on velvet or silk. If manufacturer’s
tag is missing or not coded, check with your
furniture dealer.
1b.
Check for colourfastness in an
inconspicuous place.
1c.
If possible, check upholstery stuffing.
Coloured stuffing may bleed through fabric
when wet.
1d.
Plan activities to allow upholstery time
to dry.
1e.
Remove loose dirt and impediments.
2.
Follow the instructions on page 6 for filling
the tank.
3.
Set the ReadyTools dial to the “TOOLS”
setting.
4.
Attach the cleaning tool to the end of
the hose.
5.
Plug in and turn the power switch to the
ON position.
6.
Clean by pressing the spray trigger to spray
formula onto the area to be cleaned. Slowly
move the tool back and forth over the soiled
surface. Release the spray trigger to suction dirty
water. Continue to clean in the area, working in
small sections, until dirt is removed.
Caution: Do Not Overwet.
7.
When finished cleaning, remove and rinse
tool(s) in clean, running water.
8.
It is recommended that you suction clean
water from a bowl or from the tap to rinse
out the hose.
9.
Lift end of hose and stretch out to ensure
all water is cleared from hose.
10.
Wrap flex hose around hose wrap.
11.
Empty Dirty Water Tank and rinse out,
following instructions on page 10
under “Cleaning After Use.”
12.
Return ReadyTools dial to “FLOOR
CLEANING” setting.
IMPORTANT
INFORMATION
»
Keep appliance on a level surface.
»
If your appliance has a motorised Brush Roll,
do not leave machine running in the same spot
without the handle fully upright.
»
To reduce the risk of a leaking condition, do not
store unit where freezing may occur. Damage to
internal components may result.
