Maintenance & Care
Replace drive belt
1.
Turn the power switch off and unplug the
vacuum from the electrical outlet. Remove floor
brush following steps 2-4 on page 11.
2.
With the rotating floor brush removed from
the vacuum cleaner, grasp the old drive belt and
remove from the motor pulley. Discard the old
drive belt.
3.
Place the new drive belt over the motor pul-
ley, pass the belt through the opening of the belt
ON/OFF mechanism and loop the belt over the
rotating floor brush in the space between the
bristles.
NOTE: It is important that you use only genuine
BISSELL replacement belts. Generic belts many
not meet the exact specifications required to
keep your vacuum operating at its peak perfor-
mance. The use of unbranded belts could lead
to early failure of the vacuum and could void
your warranty.
4.
Place ends of the rotating floor brush down
into the slots on the sides. Alignment of brush
ends is necessary
to ensure the brush is fully inserted.
5.
Turn the rotating floor brush by hand several
times. If properly installed,
the drive belt will center itself on the rotating
floor brush crown.
6.
Place the brush cover back and secure with
its screws.
6.
2.
rotating
floor
brush
motor
pulley
www.BISSELL.com
12
