11
w w w . b i s s e l l . c o m
M
aintenance and care
Cleaning the pre-motor filter
The pre-motor filter protects the motor from
dirt and dust particles.
1.
Unplug the vacuum from electrical outlet.
2.
Open the dust bag compartment by lifting
up on the latch on the door at the front of
the vacuum. Lift out the dust bag holder and
dust bag.
3.
Remove the filter frame from the filter holder
by grasping the lip of the frame and pulling
up.
4.
Remove the filter from the filter frame and
clean by hand washing in warm water. A mild
detergent can be used if desired. Allow the
filter to air dry thoroughly before replacing.
5.
Place the filter back into the filter frame and
replace back into the filter holder.
NOTE: The filter frame should be placed so
the protective frame is visible.
6.
Place dust bag holder and dust back into
the dust bag compartment, making sure the
entire bag is tucked in below the seal gasket.
7.
Close dust bag compartment door and press
down gently until it locks into place.
Washable Pre-
Motor Filter
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete or
ashes will damage the motor and void
the warranty.
Tip:
For maximum cleaning performance,
check the filters often and clean or
replace if necessary.
WARNING:
Do not operate cleaner
with damp or wet
filters or without all
filters in place.
3.
