52
40016512
53
11/2017
Pairing
essential procedure when you first turn the appliance on!
Make sure you only pair one appliance and one remote control at a time.
LED
:
To ensure the LED can be seen properly, you can pair your appliance before
fitting it on the wall, or else use a small mirror.
The first time the appliance is turned on, the LED turns on as a
steady magenta
light
, to show that pairing has not yet been done (see
chapter 4.2
).
Procedure using the unit on the back of your appliance:
WARNING!
You must
always
first activate the pairing function on the appliance itself, before
activating it on the remote control.
1) Press on the LED once, on the back of the appliance.
Wait until the LED stops flashing magenta and changes colour.
2) Press again on the LED on the back of the appliance.
The LED flashes magenta again. You then have one minute to pair your appliance with the
remote control.
WARNING
The appearance of the
LED may vary according
to the appliance model
(see
cover page 3
).
CLIC
Pairing (cont)
mode
boost
mode
boost
mode
boost
mode
boost
mode
boost
mode
boost
Press for 5
seconds
on the
+
key.
It searches
for the
appliance
for a few
seconds
.
If pairing fails, the display
on the control goes back to rF 0.
You can then try pairing again by pressing
the
+
key for
5 seconds
(check first that the
appliance is still ready to pair:
the LED is flashing magenta).
If pairing still does not work,
contact your dealer.
4.2 Status of LED (on radiator or towel dryer)
STATUS
COLOUR
Fixed
Flashing
Off
Green
Eco mode
•
Standby
•
Powered down
•
Stop (pilot wire)
•
Stop load
shedding (pilot
wire)
Red
Comfort mode
Boost
Blue
Frost-free mode /
Load shedding (pilot wire)
Open window
detected
Yellow
T° override°
Error
Magenta
Pairing error /
Appliance not paired
Pairing underway
Resetting the time and the day:
To reset the time and the day:
Check the remote control is turned on.
Go to settings by holding down
P1P2
and
mode
simultaneously.
Set the time and the date, press
mode
to go to the End screen, then press
mode
again to
confirm and exit.
