Before dismounting power unit or performing
any service or maintenance, follow these steps:
disengage power to equipment, lower the 3-point
hitch and all raised components to the ground,
operate valve levers to release any hydraulic
pressure, set parking brake, stop engine, remove
key, and unfasten seat belt.
Before working underneath, read manual
instructions, securely block up, and check stability.
Secure blocking prevents equipment from
dropping due to hydraulic leak down, hydraulic
system failure, or mechanical component failure.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Always wear relatively tight and belted clothing to
avoid entanglement in moving parts. Wear sturdy,
rough-soled work shoes and protective equipment
for eyes, hair, hands, hearing, and head.
Tighten all bolts, nuts and screws to torque chart
specifications. Check that all safety and cotter pins
are installed securely to ensure equipment is in a
safe condition before putting unit into service.
Dealer Set-Up Instructions
Assembly of this equipment is the responsibility of the
VH
BISON dealer. It should be delivered to the owner
completely assembled, lubricated, and adjusted for
normal operating conditions. Assembly will be easier if
components are aligned and loosely assembled before
tightening hardware. Recommended torque values for
hardware are located on page 31.
ASSEMBLY
WARNING
CAUTION
MAIN ASSEMBLY
END PLATES
C6200001
ASSEMBLY (OPTIONAL)
SKID SHOES
C6100001
ASSEMBLY (OPTIONAL)
16
21
22
ASSEMBLY TABLE OF CONTENTS
15
Assembly
