Operation
Cont´d
Tilt Adjustment
Mechanical Adjustment
turn table
NOTE:
In some cases it may not be possible to fully tilt and
angle and still be able to raise the blade high enough to
clear the ground. In this case, use less tilt.
NOTE:
It is possible for the blade to contact other
components if the blade is tilted when angled. Operate
blade slowly when angling it.
Insert the upper
pin (8) using the various hole
combinations between the main frame and the turn table
holes to achieve angle tilt positions up to 22 degrees up and
down.
Reverse Blade
The blade is reversible without removing it from the tractor.
Mechanical Adjustment
1. Remove turn table pin (7) and safety pin (24).
2. Rotate moldboard counter-clockwise 180 degrees (viewed
from the top).
3. Insert the turn table pin (7) using the various hole
combinations between the offset plate assembly and the turn
table holes to achieve angle positions up to 53 degrees each
side. Secure turn table pin (7) and safety pin (24).
Figure 4.
Upper T
Pin
urn Table
Figure 3.
Reverse Blade
RB086
RB085
24
7
8
24
10
Operation
4350-2113-00 (Rev. 09/06/04)
