Bison HHBD01SK-01, User Manual

Page: 20 / 38

20
CHAIN INSPECTION
Inspect the chain for excessive, stretch, wear, corrosion or cracks. If the load chain
shows any of these signs, the chain must be replaced immediately.
It is most vital that (P) and (D) be measured and inspected on the chain links.
1. Measure the pitch (P) for evidence of stretching. Using the table below as reference,
ensure that the measurement is within 5% tolerance of the original value. If the
measurement reading is greater than the 5% tolerance, the chain must be discarded.
2. Measure the diameter (D) for evidence of wear or corrosion. Using the table below as
reference, ensure the diameter is within 10% tolerance of the original value. If the
measurement reading is less than the 10% tolerance, the chain must be discarded.
GEAR BOX OIL INSPECTION
The hoist features a friction clutch. Ensure the oil reservoir is
always kept at a sufficient level of volume. Keep the hoist in the
natural horizontal suspended position. Locate the oil plug on
the top surface of the gear case, use
a Meropa 320 oil to fill the
reservoir till sufficiently filled, refer to the chart below. [to drain
the hoist during service or transportation, remove the plug on
the bottom of the gear case]
LOAD CHAIN WEAR
HOIST
CAPACITIES:
D A B P
1 TON 8mm 10.3mm 26.3mm 24.0mm
2 TON 10mm 12.5mm 33.2mm 30.0mm
3 TON 11.2mm 14.0mm 37.2mm 34.0mm
5 TON 11.2mm 14.0mm 37.2mm 34.0mm
GEAR OIL VOLUME
HOIST CAPACITIES: QUARTS
1 TON 1.06
2 TON 1.8
3 & 5 TON 3.17
OIL
O
FILL
DRAIN
INSPECT