Bison HHBD01SK-01, User Manual

Page: 13 / 38

13
5. Once you have worked out the number of spacers you will need, any left-over
spacers must be packed on the exposed outside end of shaft. Once you are
ready to mount the trolley.
6. To mount the trolley to the beam you must couple the motor end of the trolley
with your correct number of spacers onto the hoist, followed by the rest of the
spacers and the electrical plate.
7. The trolley which is now mounted to the hoist must be kept spread wide
enough to fit the wheels inside the beam.
8. Once the wheels are inside the beam you can push the trolley together.
9. Fit the left-over spacers on the outside of the exposed beam tight enough for
the lock pin to hold the spacers in place.
10. Make sure to secure the Lock pin with the spilt pin.
11. After the trolley has been mounted to the beam, the trolley motor must be
connected. There is a short cable from the electrical panel of the trolley which
provides power to the trolley motor.
TROLLEY MOTOR
WIRED FOR 460V
TROLLEY MOTOR CORD
(U1, V1, W1) & (U2, V2, W2)