Termaline Load Resistor 8745/8746
17
7. Prongs of the clamp match side slots in the socket holder.
8. Fit the clamp in the slots.
9. Turn the head screw up snugly.
10. Reverse steps 1 and 2.
11. Perform preoperational checkout. See “Pre-Operational Checkout” on page 6.
Replacing the Pilot Light
1. Locate the pilot lamp (P/N 5-970 (-1 or -2)) on the top of the control box.
2. Push down, gently, and twist the pilot lamp lens (P/N 8750-106).
3. Remove the pilot lamp lens.
4. Remove the pilot lamp.
5. Install the new pilot lamp by revsersing this procedure.
Additional Repairs
Repairs beyond what is covered in this instruction book will require return of
the equipment to Bird Electronic Corporation for service. See “Customer Ser-
vice” on page 18.
Storing
Note:
If the load is to be unused or stored for any length of time,
completely drain it of any coolant and cap the openings.
1. Contain or cover the unit with plastic.
2. Store in a cool, dust free and dry area.
Note:
Ambient storage temperatures are not critical, however,
extreme temperatures should be avoided.
Shipping
1. Completely drain the unit of all coolant.
2. Cap all openings.
3. Pack the unit securely in a sturdy wooden box or equivalent.
Note:
If possible, keep the original shipping carton for reshipment.
4. Pad the container with sufficient padding to avoid shock damage.
5. Seal the container securely.
Summary of Contents for TERMALINE 8745 Series
Page 2: ...I am not blank...
Page 12: ...Introduction 2...
