BIRD SignalHawk SH-36S-PC, Operation Manual

Page: 57 / 137

Settings
42
Markers Detect
Toggles the functionality of the submenu between finding peaks or finding
valleys.
Threshold
The threshold offset, displayed on the first line, is used to calculate the
threshold level, displayed on the second line, above the noise floor.
Note:
The low level peaks below the threshold level are filtered
out. Only peaks above or at the threshold level are detected.
Marker to Max Peak or Marker to Min Valley
Sets the marker to the either the maximum peak or minimum valley depending
on the functionality chosen in Markers Detect. See
"Markers Detect" on page
42
.
Marker to Next Peak Left or Marker to Next Valley Left
Cycles the active marker to the left through the points on the trace either from
highest peaks or lowest valleys (See
"Markers Detect" on page 42
) progressing
to the left.
Marker to Next Peak Right or Marker to Next Valley Right
Cycles the active marker to the right through the points on the trace either from
highest peaks or lowest valleys (See
"Markers Detect" on page 42
) progressing
to the right.
All Markers to Max Peaks or All Markers to Min Valleys
Sets all the markers to either the maximum peaks or minimum valleys
depending on the functionality chosen in Markers Detect. See
"Markers
Detect" on page 42
.
All Markers Off
Turns off all markers on the trace.
Marker Delta
Turns On/Off and displays the delta of the one to five markers.
Marker Display
Marker Type
Sets the current marker to either be displayed as a line or floating
numbered icon.
All Markers Type to Icon
Sets all markers to be displayed as floating numbered icons.
All Markers Type to Line
Sets all markers to be displayed as numbered lines.
Marker Display
Turns On/Off and sets the location of the delta display into one of the four
corners of the screen.