C
ritter
C
ritter
Blaster
Blaster
PRO
PRO
PRIOR TO INSTALLATION
Your complete Critter
Blaster Pro system
includes a control unit,
power adapter, battery
cable with clips and
four speakers. Open
the control unit by
pulling the latches
to the right and
lifting the locking tab.
Prior to operation, route the speaker and power
cables from their respective jacks on the control
panel down through the cable strain relief in the
lower part of the enclosure.
IMPORTANT: Be certain that the
power switch is in the OFF posi-
tion and the volume control is set
to the minimum (LOW) volume
level (counterclockwise) while
plugging the speaker and power
cords into the control unit.
INSTALLATION
1) Use the mounting hardware (included) to mount
the control unit box to a wall, post or other
vertical surface.
2) Plug the power adapter into an electrical outlet or
attach the battery clip assembly to a 12V battery.
The other end of the cable should already be
plugged into the power jack located below
POWER on the front panel of the control unit box.
3) It is recommended to mount the speaker(s) on
a post or surface that is aimed directly and at
the same level as the infected area.
Digital Bird Repeller
POWER SWITCH
The power switch enables the unit to operate.
Slide the switch to the ON position to start the
unit. If you turn the unit OFF, be sure to leave it off
for about 30 seconds before turning it back on to
allow the electronics to properly reset.
TROUBLESHOOTING
PROBLEM
Unit is on,
but no sound is heard
Unit is on, but plays the
same harassment
over and over,
regardless of settings
Unit is not operating
properly in the
DAY or NIGHT mode
Unit does not function
properly when connected
to a 12 volt battery
• Check volume settings
• Check time of operation settings.
• Check that at least one harassment
recording is selected to play.
Reset the unit by turning it off
for 30 seconds and then back on.
• Double check Mode
switch settings
• Make sure photocell
is not obstructed.
• Make sure the photocell is
not affected by bright lights
in either the front or the
back of the unit.
• Check battery condition
• Turn power switch on unit
to the OFF position.
Reconnect the battery,
wait 30 seconds, then
switch the unit back on.
SOLUTION
EPA Establishment Number 62617-OR-001
Pest Control Products Act #23587
P/N 655-0036-00
LIMITED WARRANTY:
This C
RITTER
B
LASTER
P
RO
unit is guaranteed against
defects in material and workmanship for six months
from date of purchase. Bird-X will replace or repair,
provided defect occurs under normal use. Units also
carry a 30-day performance guarantee. If user is not
satisfied with results, unit may be returned within 30
days for credit less a 15% handling and restocking
charge. Returns accepted only with authorization from
our Chicago office.
300 North Elizabeth Street
Chicago, IL 60607
Phone
312-226-2473
Fax
312-226-2480
Web
www.bird-x.com
Toll-free 800-662-5021
