22
4.1.3 Printer Initialization
Printer initialization sets printer paramet ers to default values. And it will not clear
downloaded files resident in flash memory.
Parameter Default
setting
Speed
50.8 mm/sec (2 ips)
Density 8
Label Width
4"(101.6 mm)
Label Height
4” (101.6 mm)
Sensor Type
Gap sensor
Gap Setting
0.12” (3.0 mm)
Print Direction
0
Reference Point
0,0 (upper left corner)
Offset 0
Tear Mode
On
Peel off Mode
Off
Cutter Mode
Off
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop
bit
Code Page
850
Country Code
001
Clear Flash Memory No
Please follow the steps below to initialize the printer:
1. Turn off the printer power.
2. Hold down the
PAUSE
and
FEED
buttons and turn on the printer power.
3. Do not release the buttons until the three LEDs flash in turn.
Note 1: Printing method (thermal transfer or thermal direct printing ) will be
set automatically at the activation of printer power.
Note 2: When printer initialization is done, sensor sensitivity is reset to
default. Sensor calibration is required before printing labels.
Note 3: Download files will not be deleted after printer initialization. For
more information about deleting files, please refer to TSPL2
programming manual KILL command.
Summary of Contents for BP-744
