Chapter 2
BIOS Setup
2-21
UART Mode Select
This item allows you to determine which Infra Red (IR) function of
onboard I/O chip.
The Choices:
Normal
(default), AS KIR, IrDA.
RxD, TxD Active
This item allows you to determine which Infrared (IR) function of
onboard I/O chip.
The Choices: Hi / Lo
(default), Hi / Hi, Lo / Hi, Lo / Lo.
IR Transmission Delay
This item allows you to enable/disable IR transmission delay.
The Choices: Enabled
(default), Disabled.
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port.
Full-duplex mode permits simultaneous two-direction transmission.
Half-duplex mode permits transmission in one direction only at a time.
The Choices: Half
(default), Full.
Use IR Pins
Consult your IR peripheral documentation to select the correct setting of
the TxD and RxD signals.
The Choices: IR-Rx2Tx2
(default), RxD2, TxD2.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller
with which I/O Address.
The Choices:
378/IRQ7
(default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
The Choices:
SPP
(default)
Using Parallel port as Standard Printer Port.
EPP
Using Parallel Port as Enhanced Parallel
Port.
ECP
Using Parallel port as Extended Capabilities
Port.
ECP+EPP
Using Parallel port as ECP & EPP mode.
Summary of Contents for M7VIG Pro-D
Page 79: ...04 19 2002 ...
