Page 11
©2014 BioSmart Technologies
Wall mounting of the heater takes about 5 minutes to complete and requires
a portable drill and two (2) screws. With an additional 2 screws (optional) the
unit can be secured to the wall permanently if desired. Alternately, the heater
can be mounted directly over the AC receptacle allowing the cord to be stored
in the heater’s internal cavity. This ‘look’ without the cord showing resembles a
professionally wired installation job.
The unit comes with an alternate control panel lens without buttons to prevent
child tampering. The remote supplied with the unit is then used to monitor and
control the functions of the heater.
Operation Overview
The units are self-regulating. When the heater is turned on and the heating
elements have come up to full temperature, the heater fan will turn on to increase
the airflow into the room. The fan will remain running even after the heating
elements have been shut down by the thermostat, in order to distribute the
remaining heat in the heating elements into the room and to prevent overheating
of the heating elements. Once the heating elements have cooled sufficiently, the
fan will turn off.
Note: If no stud is available use
the furnished butterfly nuts to
attach the mounting bracket to
the wall.
Use the included
mounting brackets for
heater installation.
