Page 12
Customer/Warranty Service: 800-595-9605
Operating Instructions at a Glance
Turning Power On
Press the POWER button on the left side of the Control Panel. The heater’s ceramic
heating elements will light up inside the heater. After a few minutes, once the air
within the heater is warm, the heater fan will begin to operate.
Select your Operating Preference
The air purification can be set to run independently of the heating. Use the Enter
key to cycle between:
Heating only -> Heat plus air purification -> Air purification only
Pressing Enter again resets the cycle.
Setting the Temperature
This feature allows you to set the temperature that your heater will maintain.
Press the temperature (TEMP) button on the Control Panel; the SET TEMP
indicator will illuminate and the temperature display will flash. Use the UP
and DOWN buttons to select the temperature and press the ENTER button.
The SET TEMP light will turn off, and the temperature is now set.
Setting the Timer
This feature allows you to set a future time for the heater to turn itself on. For
example, if you set the time for 1 hour, the heater will turn on in 1 hour.
1.
Turn the power off (heater must be powered off to use the timer feature).
2. Press the TIME button on the Control Panel—the two zeros to the right
will flash (:00), and the DELAY START indicator will illuminate.
3. Press the UP or DOWN button to select desired number of minutes (up to
59 minutes) that you would like the heater to wait to turn itself on.
4.
Press the ENTER button—the two zero buttons to the left will flash (00:),
indicating 0 hours have been set.
5.
Press the UP or DOWN button to the desired number of hours (up to 24
hours), and then press the ENTER button.
6. DELAY START indicator will flash until the unit comes on after waiting the
period of time you have set.
7. To cancel the timer, press the POWER button and the timer will stop.
Switching Between Fahrenheit & Celsius
Press the DOWN & ENTER buttons simultaneously and hold for about 3
seconds. The display will update automatically.
Turning Power Off
Press the POWER button located on the left side of the Control Panel. The sound
of the heater fan will continue until the heat has been completely vented, thus
protecting the unit and preventing waste by cycling the remaining heat into the
room. (NOTE: DO NOT unplug the heater until the sound of the fan has stopped.
Doing so may cause damage to the unit.)
