October
15
2009
–
Installation
Guide
Draft
–
Edit
Purposes
Only
Page
72
Installation Guide – October 2009 – Edit Purposes Only
2009
Disconnect the sensor module wiring harness from the internal device connector. It
might be necessary to rock the connector back and forth to work it out. Do not pull
with excessive force as you might damage the mating connector.
Disconnect the sensor module wiring harness from the sensor module. Do not damage
the wiring harness as it will be re-used with the new sensor module.
Reassembly is the reverse of disassembly.
CAUTION
The parts shown are assembled at the factory and are not meant to
be removed by the end user. Removing any of these parts will void
the warranty.
Figure 7-5 Non-Removable Parts (V-Station 4G)
7.1.1.3 CALIBRATING THE SENSOR
After a device sensor is replaced, it must be calibrated before it can be used (Only
available for UPEK sensors).
To calibrate a device:
8. Select
Sensor Calibration
in the
Tools
drop-down menu. The Calibration Wizard
appears.
