22
• Press the
ON/OFF
button again to turn the monitor on.
• Press the
“S” SET
button to enter into the Memory Recall. You will see
M
with a number on
the screen.
o In
Standard Mode
the number underneath the M indicates the stored number of
measurements in the memory. For example: “M-7” is 7 stored measurements. You
would press the
“S” SET
button to scroll through each reading. The readings are
displayed newest to oldest, 7 being the newest reading.
o In
PulseScan Mode
the M icon will display “M-A” this indicates you are reviewing
the average measurement of the 3 consecutive measurements last taken. When you
press the
“S” SET
button again, it will then display “M-3” the 3rd measurement
taken, press the
“S” SET
button again and it will display “M-2” displaying the 2nd
measurement taken, finally when you press the
“S” SET
button again the icon will
change to “M-1” displaying the 1st measurement taken in the 3 consecutive readings.
NOTE:
Only 1 set of memory (Average plus the 3 consecutive readings) is saved in
PulseScan Mode.
o In
Auscultation Mode
there are no measurements stored in memory.
4.7 Clearing Values from Memory
When in Memory Recall, press and hold the “
S” SET
for approximately 5 seconds, the memory will
be erased automatically.
4.8 How To Clean The Unit After Use
Caution:
• When cleaning this unit, please unplug the AC adapter from the electric outlet. You may suffer
electric shock.
• After cleaning this unit, please dry it well and do not plug the AC adapter into the electric
outlet with wet hands. You may suffer electric shock.
General advice:
• Do not clean this unit with gasoline, paint thinner, or high concentration alcohol.
• Do not disinfect this unit by autoclave or gas sterilization (EOG, formaldehyde, or high concentration
ozone.)
1. Wipe the blood pressure monitor with a soft cloth squeezed well after moistened with water,
diluted disinfectant alcohol, or diluted detergent.
2. Then wipe the monitor with a soft dry cloth.
