5
Sensor Control Mode
–
When set to Sensor Control auto
mode, the sensor measures your indoor air quality and adjusts
the fan speed automatically to provide optimum filtration. It also
helps conserve energy by only operating the fan at higher
speeds when needed.
Remote Operation
–
The function of the Galileo
®
Wireless Air
Quality Center is similar to a remote control. From across the room,
you can operate your air cleaner – you can change speed settings,
turn off appliance or set to sensor control.
Programmable Controls
–
Gives you the flexibility to program
your air cleaner to turn on and off at your convenience.
Clock/Alarm Mode
–
Convenient clock and alarm mode
make the Galileo
®
Wireless Air Quality Center multifunctional;
and it replaces tabletop or nightstand clock. Also features a
10 minute snooze alarm.
PRE-OPERATING INSTRUCTIONS
1. Carefully unpack your air cleaner. Select a firm level place
where there are no obstructions to the air inlet or filtered
air outlet. A good location in a room is approximately 1
foot away from the wall, in a central location of your home.
DO NOT POINT AIR OUTLET TOWARDS WALL.
NOTE: IF THE FILTERS ARE ENCLOSED IN PLASTIC
BAGS, PLEASE ENSURE THAT THE BAGS ARE
REMOVED PRIOR TO OPERATION.
2. Carefully remove your Galileo
®
Wireless Air Quality Center
from the packaging materials. Select a firm level place
on a tabletop or counter where there are no obstructions
to the venting holes.
SYNCHRONIZING INSTRUCTIONS
1. Plug the air cleaner into a 120V AC electrical outlet.
The air cleaner will begin to beep continuously until it is
synchronized with the Galileo
®
Wireless Air Quality Center.
2. Plug the Galileo
®
Wireless Air Quality Center into a 120V
AC electrical outlet near the air cleaner. It will beep once.
NOTE:
The Galileo
®
Wireless Air Quality Center is designed
to operate up to 30 feet from air cleaner.
3. Synchronize the appliances by simply pressing the ON/OFF
button on the Galileo
®
Wireless Air Quality Center. The air
cleaner will beep in rapid succession for a few seconds.
The Galileo
®
Wireless Air Quality Center is now ready to
operate with your air cleaner
PROGRAMMING INSTRUCTIONS
Clock
When the Galileo
®
Wireless Air Quality Center is plugged into
the electrical outlet, the time will automatically be set at 12:00
AM. After the clock has been set, it will show current time as
Problem
Unit will not
operate
Decreased airflow
Galileo
®
Wireless
Air Quality Center
is not controlling
unit
Air Quality Sensor
lights are always
green
Excessive Noise
Solution
•
Check to make sure the unit is
plugged in
•
Check to make sure the unit is on by
pressing the power button
•
If the Filter Service Indicator is red,
the PERMAtech™ filter should be
cleaned.
•
Check the filter to make sure they are
in good condition.
•
Check to insure nothing is blocking
air inlet and filtered air outlet.
•
Make sure the Galileo
®
Wireless Air
Quality Center is synchronized with
the air cleaner by following synchro-
nization instructions.
•
The Air Cleaner and Galileo
®
Wireless
Air Quality Center can be re-synchro-
nized by holding down the ON/OFF
button on both the Air Cleaner and
the Galileo
®
Wireless Air Quality Center
at the same time for 5 seconds until
you hear a rapid beeping sound.
•
Chances are there are low levels of
airborne particles around the sensor.
This should not be a concern.
•
Remove the plastic bags from the
filters if present.
TROUBLESHOOTING
12
BAP2000/200105EM1 P.qxd 5/20/05 16:04 Page 9
