F e AT U R e S - O P e R AT I O N S
F e AT U R e S - O P e R AT I O N S
TeCHNICAL SPeCIFICATIONS
• Wattage: 1500W/ (+ 5% - 15%)
• Working Voltage: 120V AC/60 HZ
PRe-OPeRATING INSTRUCTIONS
1. Carefully remove your heater from the box.
2. Check package for additional parts if unit is
not shipped already assembled.
3. Make sure the Mode/Adjustment knob is in the OFF
(O) position before plugging the heater into the outlet.
4. Place the heater on a firm, level surface.
5. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 Watts,
this unit draws 12.5 Amps.
TURNING THe UNIT ON/OFF ANd
SeTTING THe THeRMOSTAT
1. Plug unit into wall socket.
2. Turn the Mode Adjustment knob clockwise from the (0)
position to either 1 (Low setting) or 2 (High setting) to
get a constant heat output.
3. To find the ideal thermostat setting, turn the Thermostat
Adjustment Knob clockwise to the highest setting.
4. When the desired temperature is reached slowly turn
the Thermostat Knob counter-clockwise until the heater
turns off.
5. The heater will now automatically maintain the
temperature at the required level.
6. To turn the unit off turn the Mode Adjustment Knob
counter-clockwise to the (0) position.
FROST PROTeCT™
The heater will cycle ON and OFF as it maintains the
temperature between 40–48°F. Keep unit in 1 (low setting)
or 2 (high setting) rotate Thermostat Adjustment Knob
counter-clockwise to the lowest position. Unit will stop
working. This special setting is automatically activated. In this
mode, the heater is off until the room’s temperature reaches
freezing and the heater automatically turns on HI power.
PLeASe ReAd ANd SAVe THeSe
IMPORTANT SAFeTY INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the
following:
1. Read all instructions before using this heater.
2. This heater is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 feet (0.9 m) from the
front of the heater and keep them away from the
sides and rear.
3. Extreme caution is necessary when any heater is
used by or near children or invalids and whenever
the heater is left operating and unattended.
4. Always unplug heater when not in use.
5. Do not operate any heater with a damaged cord or
plug or after the heater malfunctions, has been
dropped or damaged in any manner. Discard heater,
or return to authorized service facility for
examination and/or repair.
6. Do not use outdoors.
7. This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. Never
locate heater where it may fall into a bathtub or
other water container.
8. Do not run cord under carpeting. Do not cover cord
with throw rugs, runners, or similar coverings. Do not
route cord under furniture or appliances. Arrange
cord away from traffic area and where it will not be
tripped over.
9. To disconnect heater, turn controls to off, then
remove plug from outlet.
10. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
11. To prevent a possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
12. A heater has hot and arcing or sparking parts inside.
Do not use it in areas where gasoline, paint, or
flammable liquids are used or stored.
13. Use this heater only as described in this manual. Any
other use not recommended by the manufacturer
may cause fire, electric shock, or injury to persons.
14. Always plug heaters directly into a wall outlet/
receptacle. Never use with an extension cord or
relocatable power tap (outlet/power strip).
15. When unplugging, be sure to pull by the plug and
not the cord.
16. If the heater will not operate, see specific instructions
on Auto Safety Shut-off.
17. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed
by qualified personnel only.
18. Discontinue use if plug or outlet is hot. It is
recommended that the outlet be replaced if plug or
outlet is hot to touch.
19. The heater must not be located immediately below a
socket-outlet. Do not use this heater in the
immediate surroundings of a bath, a shower or a
swimming pool.
SAVe THeSe
INSTRUCTIONS
Figure 3
Figure 4
Figure 2
2
3
1. Power Light
2 Mode/Adjustment Knob
3. Thermostat Adjustment Knob
1
Figure 6
Figure 5
6
7
5
7
8
5. Grill 6. Base 7. Base Mount 8. Wall Mounting Bracket
THIS APPLIANCe HAS A POLARIzed PLUG (one blade is
wider than the other). To reduce the risk of electric shock,
this plug is intended to fit in a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician to
install the proper outlet.
dO NOT ATTeMPT TO MOdIFY THIS PLUG OR deFeAT THIS
SAFeTY FeATURe IN ANY WAY.
1
2
3
4
5
6
1. Left End Cap
2. Rear Housing
3. Right End Cap
4. Control Panel
5. Grill
6. Base
Figure 1
WALL MOUNTING ASSeMbLY
(See FIG. 3–6)
IMPORTANT:
Before drilling into any wall ensure no
electrical cables are present in the area.
NOTe:
Due to the multitude of potential mounting
surfaces, mounting screws are not included with this
product. Please seek professional assistance or visit your
local hardware store to determine which type of screw is
best for your particular wall.
1. Remove Base (6) from the bottom of the
Base Mount (7). Refer to Figure 3.
2. Remove Base Mount from the bottom of the Grill (5)
by removing the two securing screws.
Refer to Figure 4.
3. Secure the Wall Mounting Bracket (8) to the wall.
Refer to Figure 5.
4. Hang the main body on the Mounting Bracket.
Refer to Figure 6.
AUTO SAFeTY SHUT-OFF
This heater is equipped with a patented, technologically-
advanced, safety system that automatically shuts off
the current to the heater when a potential overheat
temperature is reached. The heater can only resume
operation when you reset it.
To Reset the Heater
If the unit shuts down:
1. Turn Switch to OFF (O) and Thermostat
to the highest setting.
2. Unplug the heater and wait 30 minutes.
3. Plug in and turn on.
Tip-Over Shut-Off
If the heater is knocked over, it will instantly shut off.
To reset, simply place the heater in an upright position
and turn ON the heater.
deSCRIPTIONS
(See FIG.1 & 2)
BH1519_12EM1.idml 2
3/24/12 1:58 AM
