EN-3
EN
Component drawing
2
1
2
1.3 Installing the ventilation pipe
The seat top is provided with a Ø 110 mm hole for the ventilation
pipe. Install the sliding sleeve (part 3) with the Compostmixer
in the hole. Insert the ventilation pipe (part 2) only about 10 cm
inside the sliding sleeve (part 3).
Route the ventilation pipe without bends from the toilet unit over
the roof ridge along the wall either passing the eaves or through
the roof. Seal the lead-through on the roof using sealant suitable
for the roofing material. The sealant can be purchased from any
hardware store.
If you have to make some bends, take note that the curvature
of such bends must not exceed 33 degrees. Any bends in the
ventilation pipe impede natural ventilation, causing odour and
moisture problems.
Populett 200:
Saw off the sleeve from one end of the ventilation
pipe (part 2). Put the pipe cap (part 1) on the ventilation pipe
to ensure that rainwater cannot enter the toilet. It is possible to
improve the ventilation and the evaporation of moisture using the
Biolan Wind Fan (see Accessories on page EN-8), available as
an option.
Populett 300:
Saw off the sleeve from one end of the ventila-
tion pipe (part 2). Install the Wind Fan on the ventilation pipe.
Remove the 75 mm reduction sleeve from the Wind Fan before
installation.
Any bends in the ventilation pipe impede natural
ventilation, causing odour and moisture problems.
3
6
5
13
11
12
8
4
8 9 10
19
17
16
13
11
12
20
18
14
15
