bioBidet BB-2000, Owner'S Manual

Page: 17 / 21

32 33
TROUBLE SHOOTING
Trouble Cause Remedy
The
washing
water
does not
spray
1. The water tank
is not filled.
2. The shut off valve
is closed.
3. Freezing inside the
main unit or the water
supply pipe.
1. Wait about one minute.
2. Press the desired washing
button once again.
3. Turn on the shut off valve
to open.
4. Heat the room
(for about two hours).
Operating the unit while
parts are frozen will cause
a malfunction.
The unit
is not
operating
1. Disconnected the
power cord.
2. The seat is not
occupied.
3. The battery of remote
controller is exhausted.
1. Connect the power cord.
2. Check the power supply
system in your house.
3. Occupy the seat (The unit
has an occupied sensor).
4. Replace the battery.
Water is
leaking
Check the water
supply system
If water is leaking from the
main unit, call the service
center or the place you
purchased unit.
The washing
water pressure
is weak
1. The water pressure
level is set to “LOW”.
2. The strainer is clogged.
1. Set the water pressure
to “HIGH”
2. Clean the strainer.
The washing
water is not
warm
1. The water temperature
is set to “LOW”
2. Continuous operation
has depleted the
supply of warm water.
1. Set the water
temperature to “HIGH”
2. Wait about three minutes.
The seat and
dryer is not
warm
The seat & dryer
temperature is set to
“LOW”
Set the seat & dryer
temperature to “HIGH”
WATER DRAINING
Do not drink the drained water. Do not insert finger into the drain
hole. Before draining, unplug the power cord and wait 30 minutes
until the unit has cooled down.
Draining the Warm Water Tank in the Unit
Maintenance For Winter Season
If you do not intend to use this
product for 14 days or longer,
Drain the water from this product’s
warm water tank.
1. Disconnect the power plug.
2. Close the water shut
off valve.
3. Press the drain lever until the
water is completely drained
from water tank.
4. To re-supply water after
draining,open the water
shut off valve.
1. Check the power cord if it is plugged in or not.
2. Keep the water temperature on “Middle or High Level”
to prevent water from freezing.
3. If you do not intend to use the unit for 14 days or longer,
disconnect the power plug and drain the water.