BIO RAD PowerPac Universal Power Supply, Instruction Manual

Page: 19 / 42

PowerPac Universal Power Supply Instruction Manual
Page | 11
3.2.2 Edit a Template
Step Procedure Description
1. Select the template to
edit.
Starting at the Home screen, press the up/down arrow keys to
highlight the template you want to edit.
2. Enter the edit mode.
Press to access the template’s parameter screen.
3. Adjust the run
parameters.
The following screen
shows the factory default
parameters for the TGX
template:
The parameter ranges are as follows:
• V (volts): 10–2500
•
mA (milliamps): 10–2500
• W (watts): 1–500
•
hh:mm (timer hours and minutes): 00:01–99:59
• VHOURS (timer volt-hours): 1–99999
a. Use the alpha-numeric keypad to enter the Constant value.
b. Press the NEXT soft key to highlight the timer value.
c. Do one of the following, depending on the timer mode you
need:
•
Timer hours/minutes (default):
i) Use the alpha-numeric keypad to adjust the timer
value.
ii) Press the NEXT soft key.
• Timer volt-hours:
i) Press the NEXT soft key.
ii) Use the up/down arrow keys to set the timer
mode to VHOURS.
iii) Press the PREV soft key or to highlight the
timer value, and use the alpha-numeric keypad to
enter the volt-hours value.
iv) Press the NEXT soft key.
•
Untimed:
i) Press the NEXT soft key.
ii) Use the up/down arrow keys to set the timer
mode to VHOURS.
d. Press the NEXT soft key (twice for timed runs) to highlight
the top-right limits parameter, and use the alpha-numeric
keypad to set the parameter value.
e. Press the NEXT soft key to highlight the lower-right limits
parameter, and use the alpha-numeric keypad to set the
parameter value.
4. Return to the Home
screen.
Press to return to the Home screen.
NOTE:
The template (method) is automatically saved with the
new parameters.