Section 2a –
INSTALLATION
Main Components
Tri-Sensor
Assembly
Cell for ST60 = RC13
Union
Flow In
Flow Out
Soft Touch
Control Box
CONTROL BOX
converts incoming
ELECTROLYTIC SUPERCELL
TRI-SENSOR ASSEMBLY
AC power to a Low Voltage DC current,
receives Low Voltage DC current from
ensures that adequate
flow
which energizes the Cell(s). Set the
the Power Circuit Board, which initiates
94.5 L/min (25US Gallons/min)
Control Box
on a vertical surface away
the electrolytic process. This process
minimum;
salt
, 2,8 – 3,2 gm/l
from excessive exposure to heat and
converts ordinary table salt (Sodium
(2800–3200 ppm) ideal range; and
moisture. Use the template to mark and
Chloride) to 100% Pure Sodium
water temperatures
, above
drill the (4) mounting holes and insert
Hypochlorite (Chlorine Bleach) or
15.6°C (60
°
F) are satisfactory to
the screws, leaving a ¼ in. gap. Hang the
Bromine (with the addition of Sodium
prevent abusive conditions for the
control box on the screws and level.
Bromide), which in turn sanitizes your
cell to operate. See page 10 for
Remove the cover by following the steps
pool or spa.
instructions to remove and inspect
on page 10 to access the mounting
See page 8 for salt requirements.
the tri-sensor assembly.
holes to tighten the screws.
RATINGS:
Input Power: 115 VAC (3.0 AC amps)
Maximum
Output:Equivalent to 0.77 kg (1.68 lbs) of free available chlorine/day
230 VAC (1.5 AC amps)
RC-13 CELL @ Cell Power Level 3 (8 amps DC)
50/60 Hz
Cell Life Expectancy: A minimum of 15,000 ampere/hours
Output Power: Cell Power 1 (5.0* DC amps)
Agency Approvals: NSF, ETL us, ETL c, CE
Cell Power 2 (6.5* DC amps)
Cell Power 3 (8.0* DC amps)
*Indicates nominal amperage output. The dual axis controller will slightly vary the amps to optimize the power to the cell.
The cell and tri-sensor are located in a Patented Automatic Flow Bypass Manifold Assembly. 3.6m (12ft.) of
Cell and Tri-Sensor
cords
are provided with the unit. Ensure that the manifold is located within that distance from the control box with enough slack to
allow for removal for service or maintenance.
CAUTION:
It is suggested to locate the cell downstream of all other equipment and on the pool return line only to avoid over-
saturation conditions of your spa. For applications other than as recommended, contact the factory.
4
