9
6. Unzip sleeve/garment gently down to bottom stop (zipper does not separate). Place garment onto arm
or leg and zip up to top of garment.
7. Press PUMP SWITCH (#1) up to the “ON” position. Allow two to three complete inflation / resting cycles
before the garment reaches its pre-set therapeutic pressure.
8. As each chamber of the garment inflates, the PRESSURE GAUGE (#3) will dip down momentarily then
return to reflect the actual pressure in each chamber. This will continue as each chamber becomes
pressurized with each cycle.
INTERNAL ONE HOUR TREATMENT TIMER
The Model #SC-3008 Sequential Circulator is equipped with a one hour internal treatment timer which au-
tomatically begins at the start of your treatment with the pump/controller shutting off once the one hour
treatment time has been reached.
After taking a full one hour treatment, the pump/controller will automatically shut itself off. Note that alt-
hough the switch light will go out, the switch itself will remain in the “On” position. As a result, prior to tak-
ing your next treatment, you must first flip the “On/Off” switch down to the “Off” position, wait at least 10
seconds (enabling the pump to again re-set itself for another one hour treatment cycle), then flip the switch
up again to the “On” position, at which time you will note that the switch will light as you begin your next
treatment.
END OF TREATMENT
When your treatment time is completed, press the PUMP SWITCH (#1) down to the “OFF” position.
As noted earlier, although the pump shuts off, the switch may remain lighted until the timer completes it
cycle, at which time it will automatically shut off. Unplugging the power cord at this point will cut total
power to device.
Once the light has shut off, it is also safe should you desire, to remove the garment.
1. Squeeze Latch Connector Bar (#8) and pull outward to remove garment from pump.
2.
First gently bend your arm or leg (depending where garment is located) to release some air from
chambers.
Summary of Contents for SC-3008
Page 15: ...13 ...