Bio Compression Systems SC-2004-DL, Operating Instructions Manual, Page: 9 / 20

9
Preparing the Device for Use

Remove garment(s) and cardboard underneath from box

Remove garment(s) from plastic bag, unroll, and spread flat

Lift pump out of box and remove protective end caps
– save packaging
for transport and storage

Place pump on a flat sturdy surface
– pump must be close enough for
the controls to be reached during use

Attach power cord and plug into outlet

Pump is set to run for one hour at 50 mmHg with 90 second cycle time
- to change settings or use Focus Therapy, see below
To Change Pump Settings or Use Focus Therapy

Begin with the pump turned off

Press and hold “SET” button for 5 seconds

“SEtUP” will appear in LED Display and “Pressure” LED indicator will
be lit

Use UP or DOWN button to adjust pressure and press “SET” button
when finished

“SEt” will appear in LED Display and “Cycle Time” LED indicator will be lit

Use UP or DOWN button to adjust cycle time and press “SET” button
when finished

“SEt” will appear in LED Display and “Treatment Time” LED indicator
will be lit

Use UP or DOWN button to adjust treatment time
– to set on
continuous mode, press UP button until LED Display shows “COn”

Press “SET” button when finished – “SEt” will appear in LED Display
and “Focus Therapy” LED indicator will be lit

Use UP or DOWN button to select chambers for focus therapy or select
“off” to turn off

Press “SET” button when finished – “SEt” will appear in LED Display
and pump will turn off
Connecting the Garment(s)

Locate the connector bar at the end of garment tubing

Line up numbers on connector bar with numbers on pump

Squeeze the sides and insert into pump
– you will hear a “click”
when connected