Bio Compression Systems SC-2004-DL, Operating Instructions Manual, Page: 10 / 20

10

(SC-2008-DL only) Locate the second connecter bar and repeat
previous steps

When using two garments, remove blocker bar(s) and repeat previous
steps
Putting the Garment(s) On

Leg sleeve: unzip, place foot in and use straps to guide garment on,
pull up zipper to secure

Arm sleeve: slide arm through larger opening
Operating the Device

Sit in a comfortable reclined position with legs elevated within reach of
controls

Press
“Power On/Off” button to turn on

The settings will appear on the LED display and the pump will start

To pause treatment or change pressure during treatment, see below

At the end of a timed treatment, your pump will turn off

To turn off the pump during a tr
eatment, press the “Power On/Off”
button
– “HOld” will show in the LED and then the pump will turn off

Squeeze sides of connector bar and pull to disconnect garment from
pump

Press garment to remove remaining air until loose enough to remove

Unzip (if applicable) and remove garment
Pausing Treatment

To pause treatment, press “Play/Pause” button and “PAUSE” will
appear on the LED display

“HOld” will show in the LED display while the pump returns to its
resting position and then
“PAUSE” will appear. The garment will then
deflate (remove garment using directions above)

Press “Play/Pause” to resume treatment – when using timed treatment,
the remaining time will appear on the LED display